BLUM MINIPRESS top M70.2000, Safety Instructions, Set-Up Instructions And Instruction Leaflet, Page: 45 / 56

45
MINIPRESS top
Troubleshooting
Problem Possible cause Solution
Drillings are
off-centre or in the
wrong position. Ruler not set properly. ➢ Set ruler to the 0 point.
Chips between the ruler and the
work piece. ➢ Remove dirt and chips.
Drilling depth not reached. Chips in the travel path. ➢ Remove chips from the travel path.
Length of drill bit is under 57 mm. ➢ Set the drill bit to 57 mm length or
change.
Work piece thickness less than 16 mm.
Machine is running into an object. ➢ Remove object.
A Blum work table is not being used. ➢ Only use original accessories and
spare parts.
Error during insertion. Chips in the drilling. ➢ Remove chips from the drilling.
The diameter of the drillings is too small. ➢ Check the drilling diameter.
Drillings are not deep enough. ➢ Set the drill bit to 57 mm length or
change.
➢ Residue material thickness is set
incorrectly.
The surface of the work piece is too
hard. ➢ Bevel drilling.
Insertion ram is running into an object. ➢ Remove object.
Air pressure is too low. ➢ Set air pressure.