BLUM AVENTOS HF, Original Installation Instructions

Page: 21 / 24

Problem Possible cause Remedy
3 Front does not open
when pressing on the
front, but it does close
when pressing the
SERVO-DRIVE switch No Blum distance bumper is
installed
╵→ There is no 2 mm bumper path Install Blum distance bumper
→ see planning information
Contents are in the way Remove contents
SERVO-DRIVE switch or Blum
distance bumper are positioned
incorrectly Correct drilling positions
→ see planning information
Front is not balanced • The lift mechanism must be set so
that the front remains open in dif-
ferent positions
• Start a new reference run
Front is warped
╵→ SERVO-DRIVE does not acti-
vate when pressing on the front
Replace front
Front is warped and lies on the cabi-
net on one side
╵→ Leaning protection is activated Replace front
4 Front does not open or
close completely Contents are in the way Remove contents
Reference run was interrupted Reset reference run (Reset Motion)
and restart it
• Front is not balanced
• Lift mechanism has shifted • Lift mechanisms must be set so
that the front remains open in dif-
ferent positions
• Start a new reference run
Drive unit is defective Replace drive unit
Incorrect lift mechanism type used Install the correct lift mechanism
type
2
21