AM8-D
03(5)
Mobile Phone
Pad
RF5 remote control
RC10 remote control
ON/OFF
Dim+
Dim -
: switch
: turn lighten
: turn darken
ABC is three groups. To add and remove lamps, you need to press the corresponding group
button first.
Add lamps to group A (B.C): first press'A(B.C)', re-power on the lamps that need to be
grouped, and then press the power button and'+' until the lamps flashes, indicating that the
addition is successful.
Remove grouped lamps: first press'A(B.C)', re-power on the lamps to be removed from the
group, and then press the power button and'-' until the fixtures flash, indicating that the
removal is successful.
Blueview Smart Control APP: Enter the main page, after confirming that the lamp to be
connected is in the flashing state, if not, press the reset button on the power supply until the
lamp flashes, and then click the "+" sign in the upper right corner of the interface,
automatically discover, match, click to add the scanned device.
power button
turn lighten
turn darken
light-off mode
sleeping mode
reading mode
working mode
INSTALLATION REFERENCE
8cm
0.87
5*5
18*18cm
100
6330-7310
10cm
0.86
4*4
25*25cm
64
3810-4450
12cm
0.86
3*3
33*33cm
36
2480-2870
15cm
0.92
3*3
33*33cm
36
2210-2400
18cm
0.93
3*3
33*33cm
36
1910-2050
Depth (H)
Illumination (lux)
Visual Effects
OK
White Soft Film
Density (pcs/m²)
Evenness
Spacing (X*Y)
Power Density (W/m²)
Surface Material
1. X indicates the horizontal center spacing between modules;
2. Y indicates the longitudinal center spacing between modules;
3. Single LED modules are arranged in a square, X=Y.
4. When the depth of lightbox H>15cm, use more products to satisfy Illumination demand
5. Please ask the sales for other data.
6. Customized wire length available.
7. The above data is for common demand , you can increase the density for actual demand.
8. The module rotates around the center point does not change use effect, see the figure below.
Note:
Note:
-
The connection of marked place means that it cannot be cut, see the figure above;
-
Each string of this product has positive and negative wires at the end of the eighth product.
if only the first 4 pcs are used, please connect the positive and negative wires at the end of the fourth piece;
if the number of products used is between 5-8 and you need to cut, please short the two wires at the cutting
place to ensure that the circuit is unblocked;
if one of the products is not connected in the right direction when using it , the light will not turn on;
