AM8-D
05(5)
COMMON FAULTS AND TROUBLESHOOT
Quick Guide
Problems
All LEDs can not light on.
LEDs can not light on partly.
Brightness of LED is
inconsistent tor insufficient.
LED flicker.
Automatic power protection from the open or short
circuit in output of the power supply.
Fix the short circuit problem.
Correctly connection
Check the power supply system to fix it.
Replace with more powerful power
Make sure the working voltage of the product within ±5% of standard
voltage, or keep balance by circuit power consumption.
Reduce the quantities of the product in series connection to
meet requirement.
Power on
Wrong connection of power supply.
Some switching mode power supplies are not powered.
Power supply line error.
Mistaken wire connection of some of products
Power overloaded.
Connection point fault.
Remove bad connection point.
Replace a new power supply.
Please follow the instructions
Power supply circuit excessive consumption.
Excessive quantities in series connection of the product
Switching power supply failure.
Wrong Installation or use of products
Reasons
No electric supply.
Solutions
STATEMENTS AND RECYCLING
Repair should be operated by a qualified technician, if the external circuit or main line of this product is damaged.
The parameters given in this manual are typical values and for reference only.
All illustrations and drawings in this manual are for reference.
This product is subject to change without notice.
Statements:
LED lighting products belongs to electronic products, please do recycling treatment according to the relevant WEEE directives.
Recycling:
■
■
■
■
■
BLUEVIEW ELEC-OPTIC TECH CO.,LTD
□
Tel: +86-28-8148 0011
□
Fax: +86-28-8148 1258
□
Web.: www.blueviewled.com
□
Email: [email protected]
□
Add.: No. 1000, Section 2, Konggang 2nd Road, Shuangliu, Chengdu 610207, Sichuan, CHINA
Before installation, check that the product parameters are consistent with the requirements (Seeing product specifications or product labels) Load voltage,
current, power and power supply should be matched with the product.
Follow the instructions of wiring diagram (first connect the load and then the power supply) to avoid short circuit.
Make sure the correct connection of positive and negative poles between products and power supply. Otherwise, the light will not be on.
Make sure the power cord firmly screwed into the terminal and it should not be pulled out by hands.
The terminal should have insulation,waterproof and anti-corrosive treatment.
When using our high-voltage products,
you
need to match our surge protective devices; Prevent the impact and damage of surge current on products
ATTENTIONS BEFORE INSTALLATION
■
■
■
■
■
■
■
