Page
21
of
25
The Blueprint Laboratory Confidential Proprietary Information not to be reproduced or made available to third parties without prior
consent from The Blueprint Laboratory and not to be used in any unauthorised way. © The Blueprint Laboratory Pty Ltd 2021
Figure 16: Insert through O-ring and Tighten Locking Nut
Step 4
Connect the manipulator cable by inserting the female Impulse connector and rotating the locking nut.
Connect the manipulator to the host PC running Reach Control using the same steps given in Section 1, per
your specific communication and power setup.
Figure 17: Insert Connector and Rotate Nut
