SECTION
2
BLUE
LINE THERMALWAVE
®
5M
9
3. INSTALLATION
!!!
This unit must be bolted to the floor of the
vehicle by an authorized BLUE
LINE
DISTRIBUTOR.
LIFTING THE UNIT INTO THE
VEHICLE
The
BLUE
LINE
THERMALWAVE
®
weighs
approximately 1060 lbs., a forklift is necessary to
place the unit into the vehicle. Place the forks into
the forklift slots from the front of the unit and
make
CERTAIN
that the forks are spread to the
maximum width of the unit.
POSITIONING THE UNIT INTO
THE VEHICLE
Vehicles vary in size and openings. Owners have
different preferences on where in the vehicle they
want their units positioned.
BLUE
LINE
strongly
recommends a side door installation for the
THERMALWAVE
®
.
We
DO NOT
recommend a
rear door installation.
1.Ensure that enough space is provided to assure
adequate engine ventilation as well as room for
service and maintenance.
2. The complete unit with waste tank and
accessories
MUST NOT
exceed the vehicle’s axle
weight limit.
3.
NEVER
position the console closer than 12
inches from the bottom rear of the driver and
passenger seats.
FASTENING DOWN THE UNIT
AND WASTE TANK
!!!
Prior to drilling any holes in the vehicle floor,
ensure that while drilling, you will not damage
the fuel tank, fuel lines, or any other vital
components, which could affect the safety and
or operation of the vehicle.
A. The console and waste tank mounting holes will
serve as a template. Drill six (6) 13/32 in. diameter
holes for the console and six (6) 13/32 in. diameter
holes for the waste tank.
B. Using the provided mounting hardware kit:
1.
Insert six (6) 3/8-16 x 2 ½ in. hex head cap
screws with flat washers through the
THERMALWAVE
®
console
mounting
holes, and six (6) 3/8-16 x 2 in. hex head
cap screws with flat washers through the
waste tank mounting holes.
2.
Install the provided mounting plates
underneath the vehicle floor.
3.
Screw the provided 3/8-16 hex head lock
nuts on to the mounting bolts and tighten
until the console and waste tank are firmly
attached to the vehicle floor.
