BLUEGAZ BG64, Operating Instructions, Page: 3 / 5

GB
GOOD TO KNOW BEFORE USE
Gas type: I3B / P (30)
Nominal pressure: 28 ‐ 30mBar
piezo ignition
Voltage: 220 ‐ 240V ‐ 50Hz
Overheat protection: thermostat
Fuel: LPG
Max power LPG: 4.2 kW ‐ 300gr / t
Med power LPG: 2.7 kW ‐ 200 g / t
Min power PLG: 1.4 kW ‐ 100gr / t
Maximum power heating: 2 kW
Minimum power heating: 1kW
Fan: 20W
SAFETY
Thermoelectric protection
Atmosphere analyzer
Piezo ignition
INSTALLATION AND USE
Always use an approved regulator and hose
Place on a flat surface
Do not use the heater in the bedroom,
bathroom or permanent heating. It is not
approved for use in public buildings, schools,
halls, community, housing, hospitals and
nursing homes, nursing homes, schools,
showrooms, warehouses, etc. Do not use in a
basement or below soil surface..
• Do not place the heater under or near
electrical installations.
Safety distance to the nearest object is 60 cm,
both forwards, sides and top.Do not use in
rooms less than 84m3 at max, 56m3 on medium
mode and 28m3 on min mode. Please see chart
below.
Gas stoves may be used only in dry areas, and
may not be used inside of caravans or similar
Do not place the unit near other heat sources
Do not place in premises where there is already
a gas bottle
Use only in well ‐ ventilated room and not in
areas with flammable gases or flames
The device must not be used without
supervision
The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless thay have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
If the supply cord is damaged, it shall be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
Do not cover the heater
Do not move the heater while it is operating
Do not place the heater near flammable
material
In case of gas ‐ immediately turn off gas cylinder
valve. Do not light bulbs or flames. Open doors
and windows. Have the stove checked.
Ensure that legal and approved LPG is used
Check hose and regulator regularly
The appliance should not be used during soil
surface or ground
INSTALL GASREGULATOR AND GAS BOTTLE
Screw the hose to the stove and regulator and
tighten the hose clamp
Only use approved regulator.
Screw the regulator onto the tank crane
Place the cylinder in the space
Attach the back cover on the gas stove
Open the tap counterclockwise. Make sure
there are no leaks. Use soap for this purpose (1
part soap to 1 part water). NEVER use free
flames.
STARTING GAS HEATING
Follow the "INSTALLATION AND USE" and place
the gas stove in the desired location
Open the valve on the LPG bottle
counterclockwise
Press down on the knob and hold it pressed.
Press the piezo button repeatedly until the pilot
and some of the burners lit
Keep the knob pressed for a further 20 ‐ 30
seconds
To regulate the temperature, press down the
knob slightly and rotate to the desired position
Do not move the heater when it is hot
TURN OFF GAS STOVE AND CYLINDER
Set the heaters knobs in the initial position by
turning it clockwise to position 1
Note that the valve on the gas cylinder must be
closed completely by turning it clockwise until
the tap is fully closed. The pilot flame goes out
USE OF FAN AND ELECTRIC HEATING
Plug the cord into an electrical outlet and turn
on the fan (heater must only be used with 220 ‐
240V)
When the fan is on, you can turn on the electric
heat in two steps: mode I which is rated at
1000W and mode II also turned on the effect
2000W
Shutdown, simply turn the two switches for
heat and then turn off the fan
TROUBLESHOOTING
Burner does not light up ‐ bad gas inlet, the
controller does not work, check for gas in the
bottle
The burner has misfire or turns off ‐ check for
gas in the gas bottle, check the hose
connections, consult sales store or supplier
Unstable flames ‐ replace bottle, contact sales
store or supplier
Pilot flame does not light up ‐ clogged pilot
light. Contact sales store or supplier
If the electric fan does not work ‐ check the fuse
(glass fuse 10A). Make sure the gas stove is off
and cool, and that the power cord is unplugged.
Inside the stove top left hand corner there is a
black fuse holder is opened by turning
counterclockwise. Check the fuse and replace if
necessary. Screw the fuse holder and plug in
the power cord and check. If the fan is not
working now so please contact sales store, or
supplier.
REMOVE GAS REGULATOR AND REPLACING GAS
BOTTLE
Close the valve on the gas bottle. Never change
the gas cylinder close to flames or other
flammable fluids.
Remove the gas cylinder without damaging the
flexible hose. Unscrew the regulator clockwise.
Make sure the controller connections are not
damaged. Set gas cylinder collected in a safe
place.
MAINTENANCE AND CLEANING
Do not clean the stove when it is used or is hot.
Use a soft, dry cloth
Check the rubber hose periodically and replace
if necessary. (mount not excessively long or
short tubes, 50cm is enough and the right
length).
Any repairs must be performed by authorized
personnel using original spare parts.
INSTRUCTIONS FOR STORAGE
When the season is over, you should set aside
the stove in a dry place and cover it to prevent
the dust on and in the burner.
WARRANTY
The warranty is valid for two years in the
following form:
The warranty start from the day of delivery, the
purchase certificate invoice, delivery note or
cash receipt. During the warranty period all
original defective parts are replaced without
charge for materials and labor costs.
Examination of warranty accrues only
manufacturer.
The warranty does not apply to regulator, hose,
locking ring and the parts with defects occurring
due to improper operation, maintenance or
storage. The user is in any event responsible for
any transportation costs.
ENVIRONMENT
Protect the environment. Your appliance
contains valuable materials which can be
reused or recycled. Leave it to a recycling center
when it is exhausted.
MINIMUM ROOM SIZE ANDVENTILATION
Level A * B *
1,4 kW
28 m
3
32 cm
2
2,8 kW
56 m
3
66 cm
2
4,2 kW
84 m 3 99 cm 2
*A =Room size minimum cubic meters
*B = Room ventilation minimum square meters
TECHNICAL SERVICE
If you require technical support, please
contact:
Scandy Garden AB, Box 9188, 200 39 Malmö, Sweden Tel:+4640214000, e ‐ majl:info@scandygarden.eu, www.scandygarden.eu