![background image](http://html1.mh-extra.com/html/bluebird/pr18s6fa/pr18s6fa_operators-manual_2777330029.webp)
29
STORAGE
To ready the machine for storage, follow these steps:
1. Clean the machine carefully, particularly the
chassis and working equipment. Mend damage to
the paint to prevent rust.
2. Inspect the machine for worn or damaged parts
and tighten any nuts or bolts that may have
become loose.
3. Change the engine oil; dispose of properly.
4. Open the fuel valve. Empty the fuel tank (1) and
the carburetor (2).
Winter storage
At the end of the season, the machine should be
readied for storage (or if it will not be in use for longer
than 30 days). Fuel allowed to stand for long periods of
time (30 days or more) can leave sticky residues that
can plug the carburetor and disrupt engine function.
Fuel stabilizers are an acceptable option to reducing
sticky residues during storage. If alkylate gasoline
(Aspen) is used, stabilizers are unnecessary because
this fuel is stable. However, you should avoid switching
between regular and alkylate gasoline as sensitive
rubber components can harden. Add stabilizer to the
fuel in the tank or in the storage container. Always use
the mixing ratios specifi ed by the manufacturer of the
stabilizer. Run the engine for at least 10 minutes after
adding the stabilizer so that it reaches the carburetor.
Do not empty the fuel tank and the carburetor if you
have added stabilizer.
WARNING!
Never store an engine with fuel in the
tank indoors or in poorly ventilated
spaces where fuel vapor can come in
contact with open fl ame, sparks or a pilot
light such as in a boiler, hot water tank,
clothing drier, etc.
Han dle the fuel with caution. It is very
fl ammable and careless use can cause
serious harm to person and property.
Drain the fuel into an approved container
outdoors and far away from open fl ame.
Never use gasoline for cleaning. Use a
degreaser and warm water instead.
7. Lubricate all grease nipples, joints and shafts as
described in the chapter “Lubrication/Lubrication
schedule”.
8. Store the machine in a clean, dry place and cover
it for extra protection.
5. Close the fuel valve.
6. Remove the spark plug and pour about a
tablespoon of engine oil in the cylinder. Turn over
the engine so that the oil is evenly distributed and
then refi t the spark plug.
Put the engine in the compression phase where the
triangle mark on the sleeve of the starter is aligned
with the upper hole in the starter.
Note: Compression phase occurs every second
revolution.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine BlueBird spare parts.
An annual check-up at an authorized service workshop
is a good way to ensure that your machine performs its
best the following season.
8011-048
8011-131
2
1
1