ENGLISH
ENGLISH
34
35
TROUBLES SHOOTING
PROBLEM
CAUSE
SOLUTION
The garment steamer
could not be turned on.
One of the circuits has fault,
the plug is loose, the fuse is
burned, the LED supply source
is extinguished.
Check and maintain by
specialized technician.
Boiling noise can be
heard from the hose but
no steam is coming out.
The hose is twisted, bended or
being pressed onto by weight.
Raise the steam hose up to
straighten it (This will help water
to flow back into the system to
be heated).
Water leaking from the
steam nozzle.
The steam nozzle is broken or
it’s being placed hrizontally.
Seek spare part replacement.
Attempt to maneuver the steam
nozzle as instructed.
The joints of the steamer
is leaking water.
Parts of the joint is damaged,
wear down or it is not installed
correctly.
Replaced the joint. Re-install
the hose.
NOTICE
If you can not solve the problem by above method, please contact with a quali-
fied technician or after sales service center for repair.
Do not try to adjust or repair this appliance by yourself.
This mark indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for
environmental safe recycling.
ENVIRONMENT FRIENDLY DISPOSAL
7. Fill clean water into the water tank, then pour out clear water from the water outlet
at the bottom of the steamer. Repeat this step several times to cleanse the tanks &
chamber.
8. Reassembly all accessories and continue using as normal.
9. We strongly recommend to perform the above steps as maintenance regularly
by a weekly basis to prolong the lifespan of the garment steamer.
Water tank is leaking.
Water tank is broken, signs of
damage is visible.
Replace the water tank.
Steam is weak.
The power supply is lower than
demanded for the steamer.
Clogging is found within the
hose.
Install a power source stabilizer/
Performing cleaning maintenance
to remove clogging.
Water tank is deformed.
Extremely hot water was
poured inside or chemical/
strong acidic solution is used.
Only continue to use if the
deformation is still acceptable.
Otherwise, seek immediate
replacement.
No steam but the LED
indicator is visible.
Water tank is not installed
correctly.
The heater chamber is broken
or parts of the circuit are fried.
Properly install the water tank
once again. Seek for technical
maintenance from a specialized
agent.
