9
Installation
Wall Mounting (to Non-Combustible Wall Only)
1.
Fix wall mounting bracket to wall with six screws, in such a position that top of bracket is level and at
least 945mm (38”) above any surface beneath unit. This will ensure that bottom of Salamander is at
least 600mm (24”) above any surface.
2.
Fit two black plastic spacers to top rear
corners of unit. Leave them unscrewed by
approximately 5mm.
3.
Fit two adjusting screws / bolts into nutserts
at bottom rear corners of unit. These
should protrude approximately 30mm from
rear of Salamander.
4.
Lift Salamander onto wall bracket, lining up
black plastic spacers on salamander with
mounting notches in bracket.
5.
Lower Salamander onto mounting bracket.
6.
Tighten black spacers securely and adjust levelling
screws / bolts to ensure that unit is level.
~ 5mm
~30mm
Fig 1
Fig 2
Fig 3
Fig 4
Summary of Contents for G91
Page 24: ......
