BP307
www.bpfasteners.com
Page 10
Operating Instructions
Daily Function test
Always check the tool first to ensure that it does
not contains a strip or fastener. Try the tool
repeatedly pressing the muzzle bushing completely
on a hard surface and pull the trigger. You should
hear an audible clicking sound while pulling on the
trigger. Let up on the tool and make sure the barrel
is open to semi-open position.
Operating the BP307 tool
1.
After checking to make sure that the tool is
not loaded, pointed in a safe direction and
make sure the barrel is fully extended and
close the tool to the semi-closed position.
This ensures that the piston is in position
for the next fastening operation. Use the
spall guard whenever possible to minimize
the risk of being struck by flying debris.
2.
With your finger off the trigger, place the
fastener; point out, into the muzzle end
until the end is inside the muzzle
completely. STOP immediately if required
excessive power is needed; inspect the
barrel to find out why the fastener is not
entering the fastener guide easily. Do not
continue to use the tool unless the problem
is corrected. DO NOT use excessive force
when inserting a fastener. NEVER load a
fastener with your finger on the trigger.
3.
With the tool pointed in a safe direction
and your finger off the trigger, insert the
strip in the tool through the bottom of the
handle. Make sure the load is inserted
correctly.
4.
After shooting pull the fastener guide out
on the tool and push it back in, this will
allow the strip to advance.
