BP307
www.bpfasteners.com
Page 8
Failure to follow these instructions can result in injury to the tool
operator or bystanders.
Fastener Driving Safety
1.
Only use the tool for fastening into a
suitable base material.
2.
Do not fire the tool without a fastener. The
shooting of an instrument without a
fastener can cause the piston to strike the
work surface, and can cause serious injury
to you and others in the work area.
3.
Always use spall guard protection whenever
possible to minimize the flying particles or
debris.
4.
Always hold the tool perpendicular to and
firmly against the work surface to a fastener.
Otherwise, it could allow a fastener to
ricochet.
5.
Never attempt to drive a fastener close to an
edge or other fastener. See the installation
page.
Always follow the misfire procedures.
If the tool does not fire after pulling the trigger,
continue to hold the tool against the work surface
for at least 30 seconds. Then carefully open the
tool, remove the load and put in a can of water or
other non-flammable liquid. Never discard loads
into a dumpster.
If the tool becomes stuck or jammed with a powder
charge, keep the tool pointed in a safe direction
and immediately labeled "Danger do not use
defective". Lock the tool in a box and contact your
local dealer for assistance from Bluepoint.
