BP301
www.bpfasteners.com
Page 8
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN INJURY TO
THE TOOL OPERATOR OR BYSTANDERS
FASTENER DRIVING SAFETY
1.
Only use the tool for fastening into a
suitable base material.
2.
Do not fire the tool without a fastener. The
shooting of an instrument without a
fastener can cause the piston to strike the
work surface, and can cause serious injury
to you and others in the work area.
3.
Always use spall guard protection whenever
possible to minimize the flying particles or
debris.
4.
Always hold the tool perpendicular to and
firmly against the work surface. Otherwise, it
could allow a fastener to ricochet which
could cause serious injury or death to
operator or bystanders.
5.
Never attempt to drive a fastener close to
an edge or other fastener. See the
installation page.
ALWAYS FOLLOW THE MISFIRE
PROCEDURES
If the tool does not fire after pulling the
trigger, continue to hold the tool against
the work surface for at least 30 seconds.
Then carefully open the tool, remove the
load and put in a can of water or other non-
flammable liquid. Never discard loads into a
