BP301
www.bpfasteners.com
Page 10
FASTENING TO STEEL
BP35 tool can be used for fastening on the
flat surfaces of structural steel. For steel
fastening, always maintain a minimum of 1-
1/2 "between the fasteners and 1/2"
from
any edge.
Operating Instructions
DAILY FUNCTION TEST
Always check the tool first to ensure that it
does not contains a strip or fastener. Try
the tool repeatedly pressing the muzzle
bushing completely on a hard surface and
pull the trigger. You should hear an audible
clicking sound while pulling on the trigger.
Let up on the tool and make sure the barrel
is open to semi-open position.
OPERATING THE BP301 TOOL
1.
After checking to make sure that the tool is
not loaded, point it in a safe direction and
make sure the barrel is fully extended and
close the tool to the semi-closed position.
This ensures that the piston is in position
for the next fastening operation. Use the
spall guard whenever possible to minimize
the risk of being struck by flying debris.
2.
With your finger off the trigger, place the
fastener, point out, into the end of the
fastener guide until the end is inside the
fastener guide completely. STOP
immediately if excessive force is required;
inspect the barrel to find out why the
fastener is not entering the fastener guide
easily. Do not continue to use the tool
unless the problem is corrected. DO NOT
use excessive force when inserting a
fastener. NEVER load a fastener with your
finger on the trigger.
3.
With the tool pointed in a safe direction
and your finger off the trigger, insert the
strip in the tool through the bottom of the
handle. Make sure the load is inserted
correctly.
4.
After shooting pull the fastener guide out
on the tool and push it back in, this will
allow the strip to advance.
