13.
Remove the shipping lock bolt and nut from the front end of
the sliding side safety skirts and allow the front ends to
swing down to working position.
14.
The rear frame on most models has one or more vertical
frame members in addition to the rear corner verticals.
Place adequate shims directly under each vertical member
to fill the space between the bottom frame and the floor of
the pit. Finish weld all shims.
15.
Finish weld all front frame shims securely to the front curb
angle and the front frame.
16
. Install specified dock bumpers as required. Do not use the
dock leveler without bumpers, as damage to both building
and leveler may result.
17.
Mount the operations placard, provided with these
Instructions to the wall in plain view of dock leveler
operations.
1.
Clean up the entire work area and apply touch-up paint to all
welds, scratches and burns.
2.
Test operate the unit through several full cycles of operation.
Refer to the Operating Procedures section. If problems are
noted, consult the TROUBLESHOOTING section of this
manual.
3.
Leave these Instructions with the dock leveler for use by
owner.
6.1 Installation Inspection
6. DOCK LEVELER INSTALLATION INSTRUCTIONS
U-SERIES AIRBAG DOCK LEVELER with SINGLE PUSH BUTTON CONTROLS
7
