CAUTION
•
Always keep the work area clean and free of litter.
•
Always maintain proper lighting in the work area.
•
Only trained personnel should operate or service this equipment.
•
Do not operate the restraint until the transport vehicle is parked against the dock bumpers.
•
Conduct routine inspections and maintenance. Failure to do so could cause equipment damage and or personal injury.
•
Call your authorized service representative or manufacturer immediately if a malfunction occurs.
•
If a procedure is not clearly defined in this manual, contact your authorized Service Representative.
•
Always return the restraint arm to the parked position after use.
NOTICE
•
During installation, anchors must be properly torqued to achieve the necessary anchoring strength.
NOTE:
DO NOT USE IMPACT DRIVERS.
•
Do not ground welding equipment to any electrical components.
•
Do not allow the drill to go too deeply when drilling holes in the control box. Damage to the control systems may occur.
•
Never use air to blow debris from control box. Use a vacuum to remove debris from control box.
•
Do not connect green ground lead into control box until all welding has been completed.
•
Check hydraulic fluid level.
•
Improper adjustments and / or lubrication may cause operational problems with equipment.
•
Always keep the work area clean and free of litter.
•
Always maintain proper lighting in the work area.
•
If an extension plate / box is required, securely mount it on the restraint with hardware provided before shimming and drilling.
•
Improper adjustments and / or lubrication may cause operational problems with equipment.
•
If a procedure is not clearly defined in this manual, contact your Blue Giant Dealer.
STRONGARM™ RVR303 VEHICLE RESTRAINT — INSTALLATION & TECHNICAL MANUAL
9
ISSUE DATE: OCTOBER 26, 2021 REV. 1.0 (PART # 038-953EI)
Summary of Contents for STRONGARM RVR303
Page 2: ......