Blue Giant BGN-40, Owner'S Manual

Page: 23 / 126

4-2.4. Settings and Adjustments
4-2.4.1. Set Options
To set options proceed as follows and refer to Table 4-
2 :
1. Connect the Zapi Handset, refer to paragraph
4-2.1.
2. Press the ROLL up button (1, Figure 4-2 ) and the
SET up button (5) at the same time to enter the
CONFIG MENU.
3. Press the ROLL down button (1) or the ROLL up
button (2) to find the SET OPTIONS display.
4. Press the ENTER button (3) to view the options.
5. Press the ROLL down (2) or the ROLL up button
(1) to find the option to be changed.
6. Press the SET up button (5) or the SET down but-
ton (6) until the desired value setting is reached.
The option is now set at the desired value.
7. Press the OUT button (4) to exit the options.
Figure 4-2 Zapi Handset
Table 4-2 Set Options
R6624
Parameter Factory Setting Description
TILLER switch HANDLE This option handles the input CNB#3 ( Table 4-5 ). This input opens
when the operator leaves the truck (released). It is connected to a
Keyswitch controlled voltage when the operator is present.
SET INPUT #1 OPTION #1 (Standard Version only). This option handles the digital input
CNA#15. It can be can be set as:
• OPTION #1: CNA is managed as a cutback speed input (SR#1).
• OPTION #2: CNA is managed as a digital handbrake input.
• OPTION #3: CNA is managed as an inching backward.
The input CNA#15 (
Table 4-5 ) can only be used as Aux Lowering
request when the MDIPRC is PRESENT.
This input must be connected to a Keyswitch controlled voltage.
The SR#1 becomes active when CNA#15 (
Table 4-5 ) is open.
The inching backward becomes active when the CNA#15 ( Table 4-
5 ) is closed to a Keyswitch controlled voltage.
23