26
8/7/2020
Test sensors
Test sensors periodically to verify operation. With the system disarmed, open the door or window. This
separates the sensor and magnet and notifies the system. You will hear a chime each time you open and
close the door or window.
Battery installation and replacement
Replace low batteries with a model CR2 battery, available from www.BluebyADT.com or other retailers.
To install or replace the batteries:
1.
To remove the sensor’s rear cover using your finger to pull it from the housing.
2.
Remove the existing battery and dispose of it properly.
3.
Replace with a new CR2 battery, noting the correct polarity as indicated on the battery and
housing.
4.
Verify operation after replacing the cover.
Warning: the polarity of the battery must be observed. Improper handling of lithium batteries may result
in heat generation, explosion or fire, which may lead to personal injuries. Replace only with CR2 batteries
(brands include: Maxell, Panasonic, Duracell, Renata, Energizer). Batteries must not be recharged,
disassembled or disposed in fire. Disposal of used batteries must be in accordance with the waste
recovery and recycling regulations in your area.
Keep away from small children. If batteries are swallowed, immediately see a doctor.
California only: The Perchlorate warning only applies to Manganese Dioxide Lithium batteries sold or
distributed in ONLY in California, USA. Perchlorate Material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate
4.4.
Wireless Blue by ADT Keychain Remote SKF3R0-29