FILTERS INSTALLATION
1. FILTER PACK: Ships installed in the hood. If the FILTER PACK is
not in position, the
CHECK FILTERS
indicator will light.
If the FILTER PACK
becomes clogged, the
REPLACE FILTER
PACK
indicator will glow.
To install the FILTER PACK: Position the filter pack with the
charcoal portion UP. Slide the filter pack toward the rear of the unit
until it contacts the guides on the back panel. Push the filter pack
UP into the upper opening until it rests firmly against the filter pack
seal. When up in position, holder clips can be snapped over wall
ledge on each side. To remove FILTER PACK: Grasp both holder
clips and pull INWARD until the clips clear the sidewall ledge. Then,
pull the filter pack down and out.
2.
PRE-FILTER: The PRE-FILTER ships in the FILTER FRAME. If
the PRE-FILTER is not in position, or if the PRE-FILTER is not in
the FILTER FRAME, the
CHECK FILTERS
indicator will light. If the
PRE-FILTER becomes clogged, the
REPLACE PRE-FILTER
indicator will glow.
To install the PRE-FILTER: Pay attention to the air flow markings.
The
AIR FLOW
arrow will point away from the installer. Slide the
assembly up into the front opening, behind the upper filter rail.
While pressing slightly against the bottom of the assembly, pull the
FILTER HANDLE toward you so as to engage the FILTER HOOK
over the lip of the top filter rail. Then lower and seat the assembly
into the top indentation of the lower filter rail.
3. GREASE BAFFLE: If the GREASE BAFFLE is not in place, the
CHECK FILTERS indicator will glow.
To install the GREASE BAFFLE: Slide the grease baffle up into the
indentation of the upper filter rail, then lower and seat it into the
bottom indentation of the lower filter rail. Pull toward you and
downward to verify the GREASE BAFFLE is properly seated in the
lower
frame
rail.
NOTE:
The GREASE BAFFLE and
FILTER PACK activate
mechanical switches, and the
PRE-FILTER activates a
vacuum switch, to verify that
the filter elements are in their
proper positions.
All filter elements must be
properly installed or the
cooktop will not be energized.
Also, the
CHECK FILTERS
indicator will light.
IMPORTANT:
The filter hook prevents the
PRE-FILTER from being
drawn in during operation.
After installation, press
against the top of the filter
frame to verify proper
engagement of the filter hook
over the lip of the top filter
rail.
IMPORTANT:
Protect the surface of
ceramic cooktops from dam-
age in the event a filter is
accidentally dropped.
INSTALLATION (continued)
FILTER
RAIL
FILTER
HOOK
FILTER PACK
PRE-FILTER
ASSEMBLY
GREASE
BAFFLE
GREASE
TROUGH
GREASE
CUP
A
IR
F
L
O
W
HOLDER CLIP
FILTER PACK
POSITION
SWITCH
GREASE BAFFLE
POSITION
SWITCH
FILTER PACK
SEAL
PRE-FILTER
NOTE: AIR FLOW ARROW
POINTS
FROM
INSTALLER WHEN
PROPERLY INSTALLED
AWAY
FILTER
FRAME
NOTE: PRE-FILTER IS SENSED
AS BEING IN POSITION BY THE
PRESSURE DROP ACROSS IT.
FILTER HOOK
FILTER
HANDLE
FILTER PACK
SEAL
HOLDER CLIP
CLIPS ONTO
LEDGE
W
A
L
L
O
F
U
N
IT
P
R
E-
FI
LT
E
R
Fig. 7 Filter Installation
11
504
p/n
3039
03
o
p
M
W
V
-4H V
entle
ss Ho
tpla
te Coo
k
top
