OPERATION
A. START-UP
For initial start-up, or if the dispenser has not been used for an
extended period of time:
♦
Be sure the water supply is properly connected and the water
supply valve is turned
ON
.
♦
Be sure the WATER TANK IS FILLED.
IMPORTANT:
Fill the water tank before energizing this dispenser.
1. Verify the water supply is properly connected and the water supply
valve is turned
ON
.
2. Be sure the TANK HEATER SWITCH is
OFF
before connecting
the dispenser to electric power. Plug the power cord into an
appropriate electrical receptacle.
3.
Allow the tank to fill for several minutes. Place an empty container
under the dispense nozzle.
Press and hold the SAFETY switch, then press the DISPENSE
push-button. When water flows from the nozzle in a steady stream,
tank is full.
4.
Press the TANK HEATER SWITCH
ON
. When READY light glows,
unit is ready for use.
5. Be sure the DRIP TRAY is empty and the CUP GRID is properly
installed. Locate the cup grid and drip tray in place under the
dispense nozzle.
B. USING THE DISPENSER
Place a cup on the cup grid. DO NOT hold cup while filling.
Press and hold SAFETY switch.
Press DISPENSE push-button. Release when water in cup reaches
desired level. Release SAFETY switch. Remove cup from cup grid.
Be careful not to spill or splash water from cup
7
7145
77380
Ow
ners
M
a
n
ual Hor
iz
o
n
™
0401 H
o
t
W
a
ter
Dispen
s
e
r
IMPORTANT:
TANK MUST BE FULL
OF WATER BEFORE
CONNECTING BREWER
TO ELECTRIC POWER.
Heating elements will be
damaged if allowed to
operate without being
fully submerged in water.
Damage caused by
operating the brewer
without water in the tank
is
NOT COVERED BY
WARRANTY
.
CAUTION:
BURN HAZARD
This appliance dispenses
very hot liquid. Serious
burns can occur from
contact with dispensed
liquids.
DO NOT hold cup while
filling.
DO NOT spill or splash
water from cup.
