OPERATION - BREWING COFFEE
1.
Unlock the pod holder by pulling the LOCKING LEVER fully
forward.
2. Pull the BREW TRAY fully forward, then lower tray.
NOTE:
Normally, the brewer will automatically discard the last pod.
If the brewer has not been used for some time, the used pod may
need to be removed by hand. Deposit the used pod in the pod bin.
3.
Center a fresh pod on the grid of the LOWER POD HOLDER.
4. Raise the BREW TRAY and slide fully to the rear.
5. Gently pull the LOCKING LEVER
DOWN
, then push it fully to the rear
to lock the pod holder.
6.
Place an
EMPTY
cup on the CUP GRID, under the BREW NOZZLE.
7. When the READY light glows, press the appropriate BREW KEY.
Fresh coffee (or tea) will begin to fill the cup.
Three beeps will sound. When all dripping stops, beverage is ready
to serve.
SUGGESTION:
If the brewer is likely to remain unused for some time,
discard the used pod:
1. Unlatch the pod holder by pulling the LOCKING LEVER fully
forward.
2.
Pull the BREW TRAY fully forward. This will automatically eject the
used pod.
3. Slide the tray fully to the rear. In order to prevent an unintended
brew, do not lock the pod holder.
9
CAUTION:
BURN HAZARD
Exposed surfaces of the
brewer may be HOT to the
touch, and can cause
serious burns.
CAUTION:
BURN HAZARD
To avoid splashing or
overflowing hot liquids,
ALWAYS place an EMPTY
cup on the cup grid before
starting the brew cycle.
Failure to comply can
cause serious burns.
CAUTION:
BURN HAZARD
After a brew cycle, pod
holder and used pod may
be HOT. Remove and
dispose of used pods with
care. Failure to comply
can cause serious burns.
NOTE:
Press the same
BREW SELECT KEY at
any time during the brew
to CANCEL.
FOR HOT WATER:
Place an empty cup on
the CUP GRID under the
FAUCET NOZZLE.
Press the HOT WATER
DISPENSE button.
Release the button to stop
the flow.
NOTE:
Hot water dispense is
disabled during brew
cycle.
If the EMPTY DRAW light
is lit, the used pod bin is
full. Remove the drip tray
assembly, then withdraw
and empty the POD
DRAWER.
