TROUBLESHOOTING SUGGESTIONS
10
SYMPTOM
POSSIBLE CAUSE
SUGGESTED REMEDY
Water won’t heat
Circuit breaker tripped, main power switch
or tank heat switch turned off
Check / reset circuit breaker.
Turn switches on.
Temperature setpoint too low
Set for desired temperature
Hi-Limit safety switch tripped
Allow to cool, reset hi-limit reset
Damaged internal component or wiring
Examine wiring & connectors, controller,
power board and heating element.
Repair/replace as needed
Coffee level too high or low
Timer out of adjustment
Adjust timer
Brew chamber overflows
Too many filter papers or wrong filter paper Use one (1) genuine Bloomfield filter per
brew
Brew chamber dispense hole plugged
Thoroughly clean brew chamber
Too much coffee or too fine a grind
Use correct grind and amount of coffee
Sprays water from brew head
Spray gasket improperly installed
Check/reinstall gasket on INSIDE of brew
head
No brew
Spray disk plugged
Clean spray disk
Damaged internal component or wiring
Check switch, timer, solenoid, Repair,
replace as needed
No brew plus no flow from hot
water faucet
Water supply OFF
Turn water supply ON
Solenoid inlet strainer plugged
Clean strainer
Water filter (if used) plugged
Replace filter element
No flow from hot water faucet
Faucet plugged
Disassemble faucet, clean
Continuous flow or drip from
brew head
Damaged solenoid
Replace solenoid
Faucet water level probe limed-up or has
calcium deposits. “service tank” indicator lit Delime faucet water tank
Poor coffee quality
Keep brewer and decanters clean. Install a taste and odor filter in water supply, and
replace cartridges regularly. Use a quality coffee with a consistent roast. Use proper
grind and amount of coffee per brew.
915 2M-Z15131 Owners Manual for 8783MCD
915 2M-Z15131 Owners Manual for 8783MCD
