12 / EN
Washing Machine /User’s Manual
Installation
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel.
(P)
C
Keep the transportation safety bolts in a safe
place to reuse when the washing machine needs
to be moved again in the future.
Never move the product without the
transportation safety bolts properly fixed in place!
3.4 Connecting water supply
C
The water supply pressure required to run the
product is between 1 to 10 bars (0.1 – 1 MPa). It
is necessary to have 10 – 80 liters of water flowing
from the fully open tap in one minute to have your
machine run smoothly. Attach a pressure reducing
valve if water pressure is higher.
If you are going to use the double water-inlet
product as a single
(cold)
water-inlet unit, you
must install the supplied stopper to the hot water
valve before operating the product. (Applies for the
products supplied with a blind stopper group.)
A
wARNiNg:
Models with a single water inlet
should not be connected to the hot water tap. In
such a case the laundry will get damaged or the
product will switch to protection mode and will not
operate.
wARNiNg:
Do not use old or used water inlet
hoses on the new product. It may cause stains on
your laundry.
1. Connect the special hoses supplied with the
product to the water inlets on the product. Red
hose (left) (max. 90 ºC) is for hot water inlet,
blue hose (right) (max. 25 ºC) is for cold water
inlet.
A
wARNiNg:
Ensure that the cold and hot water
connections are made correctly when installing the
product. Otherwise, your laundry will come out hot
at the end of the washing process and wear out.
2. Tighten all hose nuts by hand. Never use a tool
when tightening the nuts.
3. Open the taps completely after making the
hose connection to check for water leaks at
the connection points. If any leaks occur, turn
off the tap and remove the nut. Retighten the
nut carefully after checking the seal. To prevent
water leakages and damages caused by them,
keep the taps closed when the machine is not
in use.
