19
8
3
4
Filling the rinse aid dispenser
Rinse aids allow washing water to rinse off more cleanly
and prevent watermarks or streaks on the dishes.
Only use rinse aids suited to use in dishwashers.
- Note -
If you use 2 in 1 or 3 in 1 detergents / tabs, you do not
need an additional rinse aid.
Open the rinse aid dispenser by pressing the lock ( )
Carefully pour in rinse aid to the MAX mark.
Close the lid until it clicks in ( ).
Carefully wipe off spilled rinse aid. Excessive rinse aid
causes excessive foam formation, which may hinder
cleaning.
Set the dose of rinse aid
The dose of rinse aid to be used can be set by means of
the dispenser regulator between levels 1 and 6 ( ). Your
machine is pre-set at the factory to level 3.
Only change the setting if the following applies after
washing:
Watermarks are visible on the dishes: Set dosage
higher
Streaks are visible on the dishes: Set dosage lower
Filling the detergent dispenser
- Note -
Only use detergents suited to use in dishwashers.
Open the detergent container by pushing the lock to the
right ( ).
Marking lines on the inside of the detergent container aid
in providing the correct amount of detergent.
The detergent container holds a total of 40 cm³ of detergent
( ).
When the dishwasher is fully loaded and the dishes are
very dirty, we recommend filling the detergent container
up to the 25 cm³ mark. When the dishes are less dirty,
it is generally sufficient to fill the detergent up to the 15
cm³ mark.
If your dishes have been in the dishwasher for some time
without being washed, additionally fill the small container
up to the top ( ).
The detergent amounts for the individual cleaning
programmes are shown in the cleaning table.
Deviations are possible depending on how dirty the dishes
are and on how hard the water is in your location.
- Food leftovers are staying on the
dishes for too long
- The machine is not grounded
properly
- Cutlery parts from low-grade rust-
free steel.
- Dish items with rust stains
Possible causes
- Moisture in the detergent
dispenser
- Detergent stays in the dispenser
of the dishwasher for too long
- The lid of the detergent dispenser
does not open.
- Detergent is moist or clumping
- Spray arm nozzles are clogged.
Turn the
lock to the
right.
A
B
25cm³
15cm³
5cm³
1
2
B
3
4
A
1
2
Detergent residue
remains in the dispenser
- Remove coarse dirt under running water and carry out the
pre-wash program with an interval of 2 days without a
detergent.
- Check the grounding of the system. Static electricity may
eat holes into metal and cause irreparable damages.
- Rust on such items cannot be avoided. Cutlery or dishes of
this type is not suited to dishwashers.
- Rusty dishes may infect other items. Cutlery or dishes of
this type is not suited to dishwashers.
How to fix these problems
- Ensure that the detergent dispenser is dry before filling it.
- Pour the detergent in just before washing.
- When loading the dishwasher, take care to ensure that you
do not accidentally open the lid.
- Store detergents in a dry location. Close the lid of the
container carefully.
- Clean the spray arms as described in the manual
