Installation
16
Oven Installation - Some Dismantling Required
OVEN REĆASSEMBLY
After the installation base has been secured in
position, connect the potable water line and elecĆ
trical wires to the base assembly. Insure that all utiĆ
lities are OFF before beginning the reassembly of
the COSĆ5HA oven. The power distribution box loĆ
cated in the base must have a service loop such
that it will reach the main input power terminal
blocks located in the center, rear of the base oven
section.
1. Remove the two 1/2" bolts from the front of the
installation base. See Figure 28.
1/2" Bolt
1/2" Bolt
Figure 28
2. Lubricate the top surface of the installation
base with a little grease or silicone spray. PosiĆ
tion the oven base section onto the flat track
surface of the installation base approximately
4" to 5". Support the front of the oven base
section with a piece of 2" pipe (2Ć3/8" OD
approximately) by 39" (minimum) long.
3. Apply a 1/8 inch bead of clear silicone RTV to
the perimeter of the top edge of the oven base
section. Lift the lower oven section onto the
oven base section. Use gloves to protect
hands from any sharp edges.
4. Install the four bolts (1/2 inch diameter) that
connect the lower oven section and oven base
section together.
Two nuts are located in the rear lower left and
right corners of the lower oven section. These
nuts can be accessed from the back of the oven
base section. See Figure 24 and Figure 25 on
page 15.
The third nut is accessed from the right side of
the oven base section. It is located in the lower
front right hand corner of the lower oven secĆ
tion. See Figure 26 on page 15.
The fourth nut is accessed from the left side of
the oven base section. It is located in the lower
front left hand corner of the lower oven secĆ
tion. See Figure 27 on page 15.
5. Carefully route the wires from the base oven
section into the lower oven section. Resecure
the conduit in place with the two screws. See
Figure 20.
6. Apply a 1/8" bead of clear silicone RTV to the
perimeter of the top edge of the lower oven
section. Lift the upper oven section onto the
lower oven section. Use gloves to protect
hands from any sharp edges.
7. Install the three bolts (1/2 inch diameter) that
connect the top and lower oven sections toĆ
gether.
Two nuts are located in the rear lower left and
right corners of the upper oven section. These
nuts can be accessed from the back of the
lower oven section. See Figure 29.
The third nut is accessed from the right side of
the lower oven section. It is located in the upĆ
per front right hand corner of the upper oven
section. See Figure 30.
