Page 7
Colorise™ Infiniwhite Manual Rev. A
© 2015 Blizzard Lighting, LLC
3. SETUP
Fuse Replacement
CAUTION!
The Colorise™ Infiniwhite utilizes a high-output switch-mode power
supply with an internal fuse. Under normal operating conditions, the fuse
should not require replacement. The fuse is field replaceable, however it is an
advanced procedure suited to qualified individuals. Should your fixture require
replacement, please contact Blizzard Lighting for instructions, or to return your
unit for service.
Connecting A Bunch of Colorise™ Infiniwhite Fixtures
You will need a serial data link to run light shows using a DMX-512 controller
or to run shows on two or more fixtures set to sync in master/slave operating
mode. The combined number of channels required by all the fixtures on a serial
data link determines the number of fixtures the data link can support.
Fixtures on a serial data link must be daisy chained in one single line. Also, con-
necting more than 32 fixtures on one serial data link without the use of a DMX
optically-isolated splitter may result in deterioration of the digital DMX signal.
The maximum recommended cable-run distance is 500 meters (1640 ft). The
maximum recommended number of fixtures on a serial data link is 32 fixtures.
Data/DMX Cabling
To link fixtures together you’ll need data cables. You should use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic
interference.
For instance, Belden© 9841 meets the specifications for EIA RS-485 applica-
tions. Standard microphone cables will “probably” be OK, but note that they
cannot transmit DMX data as reliably over long distances. In any event, the
cable should have the following characteristics:
2-conductor twisted pair plus a shield
Maximum capacitance between conductors – 30 pF/ft.
Maximum capacitance between conductor & shield – 55 pF/ft.
Maximum resistance of 20 ohms / 1000 ft.
Nominal impedance 100 – 140 ohms
Setting the DMX Input Connector as the Active DMX Input
Navigate the main menu to reach
SET,
press
<ENTER>,
then use the
<UP/
DOWN>
buttons until
SIGN
is displayed, then press
<ENTER>
again. Now
use the
<UP/DOWN>
buttons to highlight
CABL
(cable mode), and press
<ENTER>
to confirm.