11. Setting up of the metal detector and preparation for
work
The metal detector is ready for use when the LiPo battery is charged and undamaged (the BAT LOW
LED is not lit up).
Before initial use, please charge the LiPo battery at least 2 hours (from 2 to 4 hours), by the
automatic LiPo battery charger available in the standard package, as described in 13. The LiPo
battery reaches full capacity and respectively toughness, after at least about 5 cycles of
charge-discharge.
To optimally use the capabilities of your BLISSTOOL LTC64X, we recommend that you explore in
detail all its setting, indication and maintenance bodies by using the detailed description of them
available in 9.
After the metal detector is assembled according to the description in 8, it can be turned on via
turning from left (level "OFF") to right of the VOLUME potentiometer. With this potentiometer is
set and the desired audio volume (levels from "1" to "MAX").
Before initial use of BLISSTOOL LTC64X, for the beginners users we recommend to set all its
switches and potentiometers of the recommended for these levels (positions), available as described
in 9.
The choice of manual or automatic mode to eliminate the influence of the ground is done by
GROUND MODE switch described in 9.3 and the optimal way of tuning and balance, according
to the selected mode, are made according to the description available in 9.3, 9.4, 9.5 and 9.6.
The setting of the desired degree of discrimination (distinction of the metals) is made by
DISCR LEVEL potentiometer as description in 9.10. The depth of discrimination is set by DISCR
DEPTH potentiometer as description in 9.11. In 9.9 describes the DISCRIMINATOR switch.
If the target is detection of any type of metals is necessary DISCR LEVEL potentiometer to be
set at level "0". For the complete exclusion of the discrimination, DISCR DEPTH potentiometer
can also be set at "0".
In the case of ignoring of the ferrous metals (detection only of non-ferrous metals), ie this is
mode of discrimination, is necessary DISCR LEVEL and DISCR DEPTH potentiometers to be set
at least of the recommended levels present in their descriptions in 9.10 and 9.11.
The stability and the sensitivity of BLISSTOOL LTC64X is set by GAIN, FREQUENCY,
THRESHOLD, SILENCER and TONE potentiometers. They should also be set at least of the
recommended levels, available in the description in the points, respectively: 9.17, 9.2, 9.7, 9.8
and 9.18.
After implementing of the above described steps, the metal detector will be set up
and ready for use.
12. Method of search with the metal detector
The metal detector BLISSTOOL LTC64X works in motion mode, ie it reacts to a metal object buried
in the ground only when the search coil is swung above it.
The searching of metal objects is actually by moving the search coil above the ground surface.
While doing this, the search coil has to be held parallel towards the ground surface and at a
minimum distance above it. The raising reduces the search depth.
BLISSTOOL LTC64X
- User Guide (version EN201405101504)
Page 35 of 42
