detector these settings, but after checking the hole, to set of the metal detector the default settings,
through which the metal detector is balanced not to the hole, but to the terrain;
- the user to switch the metal detector to one of the other modes of the DISCRIMINATOR switch. For
example, if he currently search in mode "III", to switch to mode "II" or to mode "I";
- on terrains where the hole effect visible occurs, the user to comply with it, ie after first detected and
centered well the signal, and dug a hole to find the buried metal object, not to verify that the metal is
still in the hole, but to continue to dig until he detect the metal object in the excavated from the hole
soil.
False signal than over a blank hole, can be registered and in greater local heterogeneity (clusters) on
a particular section from the terrain, especially on terrains with a high content of ore and slag, or on
terrains whose soil is mixed with small pieces of mineralized ceramics.
In practice, such false signals, are not a serious problem, especially for experienced searchers
who through his experience, detect relatively easily the difference in the sound, at signal from
real metal object and at false signal due to the excavated hole or heterogeneity (clustering).
The sound in detecting of a signal from a metal object is a solid, brief and uninterrupted, and can be
easily centered, and in most cases, the sound of a false signal is long and scattered, sometimes
heterogeneous, interrupted or blunted.
If you are searching in areas, where ammunitions or other explosive substances may be
detected, be extremely careful when excavating, because we do not carry the responsibility for
your actions and behavior.
Do not open the box of the electronic block, because otherwise you will lose the warranty of
your metal detector. If this is necessary, please contact us, using the contact information,
given in 18, to ensure adequate support and service.
BLISSTOOL LTC64X
- User Guide (version EN201405101504)
Page 40 of 42
