8
SECTION 3 - UNPACKING
Save the two foam inserts and all packaging for future storage or shipping� Save these
instructions for future reference�
3.1
UNPACKING YOUR BLENDER
1�
You should have received the following items:
▶
Blender Base
▶
One or more blender jars with lids
2�
Remove blender base, blender jars, and lids from carton�
3�
Unwind the power cord�
4�
Check for and remove any packing material which may have blocked ventilation holes
in the blender base�
5�
Inspect all items to ensure no damage occurred in shipment�
6�
If any damage has occurred contact a Blendtec qualified service agent immediately�
3.2
RECORDING YOUR SERIAL NUMBER AND DATE OF SHIPMENT
Record your blender base serial number and date of purchase in the space below� You
will need these when contacting Blendtec for service�
Motor Serial #:___________________________________________________
(Found on bottom of motor base)
Date of Purchase:____________________________________________________
Refer to these instructions whenever service may be needed�
SECTION 4: INSTALLATION
4.1
Xpress Blender Installation
1�
Place blender base on a flat, clean, dry surface�
2�
Make sure plug outlet is available within 4 feet (1�22 meters) of the blender base�
3�
Plug the unit into a 220/240 volt receptacle with at least 7�5 amp protection� Make
sure switch is turned off before plugging in� Failure to use a dedicated line may result
in damage to the blender� Lack of adequate power causes the motor to overheat
(which shortens the life of the blender electronics�) Operating the blender in this
manner will void the warranty�
4�
Ensure that the blender base vents are unobstructed to allow for proper cooling during
use�
