Blaze Outdoor Products Instructional Book
Page | 32
Heat Separators, Flame Tamers, Grilling and Warming Racks
To clean (should clean after each use), turn the main burners on HIGH for 10-15 minutes with the hood
closed. This allows any food particles or grease drippings to burn away. Brush components with a stainless steel
bristle brush to remove any remaining charred materials.
Cast Stainless Steel Burners
The appliance must be completely cooled before proceeding. Make sure the gas supply is off and all control
knobs are in the “OFF” position. You must remove all cooking grids and flame tamers to expose the main burners
in the appliance. On the bottom rear of each burner is a cotter pin accessible from the back of the grill head.
Remove cotter pins (unless they were removed prior to installation into an outdoor kitchen). To remove burner, pull
rod upwards and slide burner toward the rear of the appliance. Repeat for each burner. To clean the burners, use a
wire brush to clean the exterior of the burner. Free all clogged ports of obstructions with a small metal object. Clean
out any debris through the air shutter and inspect the burner inlet to ensure it is free of any obstructions. Use a rod
or pipe cleaner to remove any debris within the burner if necessary.
NOTE:
Make sure each burner is properly placed after cleaning. It is very important to ensure the end of the
burner is installed appropriately onto the gas valve to ensure gas flows safely into the burner. Failure to meet
these conditions can cause dangerous conditions that can cause personal injury and/or property damage.
Optional Infrared Sear Burner
How to Replace Conventional Burner with Infrared Sear Burner (A video for installing the infrared sear
burner is located on the blaze website to assist with the below instructions,
1. To install the optional infrared burner, begin by removing the far left cooking grid, flame stabilizing grid
and zone divider.
2. Remove conventional burner by first removing the cotter pins that holds it in place
(unless they were
removed prior to installation)
, located on the bottom rear of the burner and accessible from the rear
outside of the grill body. With the cotter pins removed, remove the conventional burner.
3. Place the infrared burner in place, leaving off the flame tamer. Ensure the burner is seated appropriately
around the valve so that gas flows into the burner.
4. Replace the heat zone divider and cooking grid.
Do not use this burner with the flamer tamer
reinstalled above the burner.
