OM-PI1010A E V1.10
May 21, 2015
Page 9
PI1010A
Never try to repair or replace
any part of this appliance
unless instructions are given
in this manual. All other work
must be done by a trained
technician.
Allow the appliance to cool
down before carrying out any
maintenance or cleaning.
Maintain the door and glass
seal and keep them in good
condition. A leaking door seal
will shorten burn times and
may harm the combustor.
Avoid placing wood against
the glass when loading. Do
not slam the door or strike the
glass.
Do not throw this manual
away. This manual has
important operating and
maintenance instructions that
you will need at a later time.
Always follow the instructions
in this manual.
Do not place clothing or other
fl ammable items on or near
this appliance.
Do not use a grate or other
device to elevate the fi re off of
the fi rebox fl oor. Burn the fi re
directly on the bricks.
Ashes should be placed in a
steel container with a tightly
fi tting lid and moved outdoors
immediately. If the ashes are
disposed of by burial in soil or
otherwise locally dispersed,
they should be retained in
the closed container until
all cinders have thoroughly
cooled. Other waste shall not
be placed in this container.
SAFETY PRECAUTIONS cont.
It is recommended to install smoke and carbon monoxide detectors where heaters are
installed. Install at least one smoke detector on each fl oor of your home to ensure your
safety. It should be located away from the wood stove and close to the sleeping areas.
Locating a smoke detector too close to a wood stove can cause the smoke detector alarm
to sound if a puff of smoke is emitted while the wood stove door is open during reloading.
Follow the smoke detector manufacturers placement, installation, and maintenance
instructions.
DO NOT OVER FIRE THIS
HEATER.
Attempts to
achieve heat output rates
that exceed heater design
specifi cations can result in
permanent damage to the
heater and to the catalytic
combustor. Over fi ring the
appliance may cause a house
fi re. Never burn the stove so
hot that the stove or chimney
connector begins to glow.