OM-PI1010A E V1.10
May 21, 2015
Page 15
PI1010A
INSTALLATION INSTRUCTIONS cont.
STOVE ASSEMBLY
1. Carefully remove and inspect the insert parts in
the shipping packages. Th
e parts should include
the 2 shroud side panels, 1 shroud top panel, 1
shroud outer trim package, 1 shroud convection
deck, 2 #6-32 screws. (see
Fig. 1
)
2. Place the fi replace insert on the work area. Note:
Th
is unit is shipped without any shroud parts
in place. Attach the two-shroud side panels to
the unit by loosening the screws on the covers
on either side of the unit and sliding the shroud
sides between the covers and the unit. Retighten
the screws. (see
Fig. 2
)
3. Exact placement of the insert is determined
by the overall shape of your fi replace opening
and surround etc. First determine whether
you will need leveling bolts installed or other
devices to ensure a proper level installation of
the unit. Th
is is determined by your fi replace
construction. Sometimes the hearth is raised
from the bottom of the fi replace and sometimes
it is lowered. Only use non-combustible
material to fi ll any space under the insert
(such as fi rebricks) to support the bottom of
the fi rebox. Th
e insert must sit level with, or
slightly higher than, the hearth front. On each
corner of the underside of the fi replace insert
there is a 3/8” NC nut. If required a 3/8” bolt of
determined length can be threaded into these
nuts to assist in leveling the unit.
NOTE: Blaze King strongly recommends
that you install a complete insulated
stainless steel fl ue liner system. This
is the safest installation and will ensure
proper draft control for ideal and
consistent burn times. An approved
liner system is required by code for all
installations in Canada. The installation
codes in some USA locations do not
require a full insulated stainless steel
liner system, but it is recommended.
