Blaze King CALDERA, Users Installation Operation & Maintenance Manual

Page: 30 / 53

THE CALDERA
Page 30
LIGHTING INSTRUCTIONS - Intermittent Pilot
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the f loor because some gas
is heavier than air and will settle on the floor.
- Do not try to light any appliance.
- Do not touch any electric switch; do not use any phone in your building.
- Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
- If you cannot reach your gas supplier, call the fire department.
C. Do not use this appliance if any part has been under water. Immediately call a qualified se rvice technician to inspect
the appliance and to replace any part of the control system and any gas control which has been under water.
WHAT TO DO IF YOU SMELL GAS:
1. Read the safety information above on this label.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. Do not attempt to light the pilot by hand.
5. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP!
Follow “B” in the safety information above on this label. If you don’t smell gas, go to t he next step.
6. Turn on all electric power to the appliance.
7. You must now synchronize the remote with the Receiver/Battery Pack (for 1st time use)
Battery Pack (fig. 1 (Battery Pack is situated behind the Pedestal front or Louvers)) fol lowed by pressing the “ON” button
on the Remote.
8. Press the "ON" button on the Remote (fig. 2) or if not using the Remote turn the switch on the Battery Pack to the
"ON" position (see figure1 ).
9. If the appliance will not operate, follow the instructions "To Turn Off Gas To Ap pliance" and call your service technician
or gas supplier.
STOP!
by pressing the PRG button on the
TO TURN GAS OFF TO APPLIANCE
1. Press the "OFF" button on the remote or if not using the remote turn the switch on the batt ery pack to the “OFF” position.
(See fig. 1)
2. Turn off all electric power to the appliance.
FIG 1: RECEIVER / BATTERY PACK
#0361Se
FIG 2: REMOTE CONTROL
ON /OFF