www.blaubergventilatoren.de
vento expert (Duo) a W v.2
17
VENTILATOR PASSWORD CHANGE
TIMER SETUP
SENSOR SETUP
To change the ventilator password in the mobile application go to
Menu -
Connection - Home
.
1. Select the connection type and press the Settings button.
2. Enter and confirm the password.
3. Press the
Change Password
button.
1
2
3
To set the
"Night mode"
,
"Party mode"
timer and the turn-off delay timer for the
"Boost"
mode, go to
Menu - Settings - Timers
in the mobile application.
The
"Night mode"
timer sets transition time to the low speed after activation of the Night mode (8 hours
by default).
The
“Party”
timer sets transition time to the high speed after activation of the Party mode (4 hours by
default).
The
turn-off delay timer for the "Boost"
mode defines switch delay to the high speed after actuation of
any sensor and reset of the sensor to the standard status.
To set up sensor operation via the mobile application go to
Menu - Settings -Sensors
.
Humidity sensor:
actuation of the humidity sensor. When the indoor humidity exceeds the set point,
the ventilator goes to the third speed. When the indoor humidity drops down below the set point, the
turn-off delay timer for the "Boost" mode is activated. After the delay timer countdown, the ventilator
reverts to the previous speed setting. Sensor 0-10 V: actuation of the analogue 0-10V sensor. If the 0-10
V control signal exceeds the set value, the ventilator goes to the maximum speed. After decrease below
the set value the Boost delay timer is activated. After its operation is completed the ventilator reverts to
the previous speed.
Relay sensor:
actuation of the external relay sensor. As the NO contact of the external relay sensor
is closed, the ventilator goes to the high speed. As the NO contact opens, the turn-off delay timer for
the "Boost" mode is activated. After the ventilator operation in the Boost mode comes to the end, the
ventilator reverts to the previous speed setting.
Note:
for activation/deactivation of the sensors and setup of the sensor threshold points for
Vento Expert Duo ventilators in the Slave mode follow the steps:
•
turn the ventilator to the Master mode using the DIP switch No. 1 (refer to page 13)
•
set the ventilator into the special setup mode (refer to page 22)
•
connect to the unit via a mobile device (refer to page 16)
•
set the sensors using the mobile application
•
exit the special setup mode
•
turn the ventilator to the Slave mode using the DIP switch No. 1
