30
www.blastrac.eu
When the motor is running the screen will change a bit, in the
top left corner RUN will appear and there should be a current
greater than 0,0A. The most important change is the
parameter value, in the case of picture 0-2 this is the set disk
speed, the value marked in black is the value you can adjust
with the control wheel.
Menu’s
When the main screen is on and “Esc” is pressed you will
enter the main menu:
1.
DRI: Drive menu; the drive parameters and settings
2.
Identification: Drive information, type and software version.
3.
Interface: settings for the display language and access level.
4.
TRA: store and load the configuration on the remote.
5.
Password: to unlock the remote.
Hour timer
The operating time of the machine can be found if you follow the steps below:
1.
DRI
2.
Display
3.
Power-On time;
o
APH: Energy consumption.
o
Motor Run Time: Elapsed run time of the motor (time that the motor has been switched on).
o
Power-on time: Elapsed power-on time (time that the drive has been switched on).
o
Time Counter Reset: can reset, depending on the selection, one of the tree above values.
Fault history
The fault history of the machine can be found if you follow the steps below:
1.
DRI
2.
Display
3.
DGT
4.
Error history;
o
Here are the last 10 errors shown, by selecting one there is more info fount about the fault,
such as:
Driver state
Motor current
DC bus voltage
Language
To change the language of the machine follow the steps below:
1.
Interface
2.
Language
Select the language you want to use.
Picture 0-2 Running screen
