Blanco BFS95F, Instructions For The Use And Care And Installation, Page: 9 / 31

Equipment type: free standing (class 1)
Insulation class: class
1
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITIES FOR
DAMAGES TO THINGS OR INJURIES TO PERSONS OR ANIMALS DERIVING
FROM INCORRECT INSTALLATION OR USE OF THE EQUIPMENT.
For a situation where the appliance is between two cupboards and the anti
tilt chain cannot be fitted we suggest securing by screwing through the both
sides of the cupboards into the sides of the cooker. The screws should be
fitted as follows. Position the oven between the cupboards in it's final
position, then mark the location of the pilot hole inside the cupboard. Refer
to the diagram below for the location of the pilot hole. Use 3.5mm diameter
drill bit to drill the pilot hole through the cupboard and both sides of the
cooker. Before drilling, check your measurements to ensure the pilot holes
are located within the range specified in the diagram. A drilled hole in the
side of the cooker which is outside the range specified may void the
warrantee. Inspect cupboards thoroughly before drilling to avoid damage to
electrical wires or gas lines. Fix two 12 gauge x 40mm long self tapping
screws through the pilot holes inside both cupboards and into the side of the
cooker.
Note! Screw length is based on cupboard thickness of 20mm, gap between
cupboard and oven of 10mm. Screw length could vary depending on
cupboard material thickness and gap between oven and cupboards.
Note! The screws must be accessible for removal if the cooker requires
service. Cupboards must not be built over these screws.
9
Instructions for Installation