6
UVC INSTALLATION
UVC Lamps & quartz sleeve maintenance
The UVC lamp must be replaced every six months / once a season. It is recommended that
the lamp is replaced in the spring.
The Quartz sleeve can become coated in lime scale build up in hard water areas. This
should be carefully removed from the quartz sleeve and cleaned with a soft cloth.
A wet test must be carried out after maintenance to ensure there are no leaks before the
UVC is reconnected. pond/water feature.
Wet testing the UVC
Testing/replacing the UVC lamp
See Page 7 for illustration
1. Unlock the green UVC electronics cap.
2. Inspect the UVC cap and Quartz sleeve for water leaks.
3. Then unlock the yellow quartz sleeve end cap and unplug the lamp to replace if
desired
Warning
- 1) Always turn off the power before any maintenance to the UVC
section 2) Always view the UVC lamp through the viewing window on the UVC
Chamber 3) Direct exposure to UVC light can damage your eyes and skin.
Caution
- Inpond UVC has been fitted with a magnetic safety switch. 1) Do not
remove unit with power turned on 2) Do not place near strong magnetic fields.
IMPORTANT
- A wet test of the UVC under operating conditions must be carried
out before the UVC or electrical supply is installed. Connect the UVC to the Inpond
following all installation instructions. After running for 24 hours check for leaks.
IMPORTANT
- Ensure that the mains supply is switched off and the power is isolated
before removing the UVC cover.
