25
SECTION 5
PREVENTIVE MAINTENANCE
If the Running Belt is not centered on the Tail
roller, and is either too far to the left or right,
adjust tracking using the following steps:
1.
Turn Treadmill on, and increase speed to 3.0
mph.
2.
Use the Allen wrench to adjust the tail roller
Allen screws.
3.
By tightening the CLOSE side and loosing the
opposite (same amount), you can change
position of rear roller without changing overall
tension. Adjustments should be made in ¼ turn
increments.
4.
If the Running Belt is tracking to the left,
adjust the Running Belt to track to the right, by
turning the left tail roller screw clockwise.
5.
If the Running Belt is moving to the right,
adjust the belt to track to the left, by turning
the right tail roller screw clockwise.
6.
Wait about 30 seconds for Running Belt to
stabilize between each adjustment.
7.
After running Belt appears to be tracking
properly, increase speed to 8 mph, and verify
belt stays centered.
WARNING: MOVING
PARTS CAN CAUSE
SERIOUS INJURY!
It is recommended that the deck be lubricated
every 6~12 months according to the frequency of
usage.
Use 6mm Allen wrench to loosen the bolts in the
end caps. Remove excessive accumulations of
dust, dirt, and other substances from running deck.
Use a clean soft cloth.
Warning! Do not use cleaner under the running
belt.
Pull up running belt, dispense lubricant on deck,
and spread evenly.
After lubricating deck, center the belt, and tighten
the end caps. Check belt condition and adjust if
necessary referring to the steps above.
0.5~4.0 Miles - lubricate every 1 year
4.0~7.0 Miles - lubricate every 6 months
7.0~10.0 Miles - lubricate every 3 months
