BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
• Phone 949-206-8152 • Fax 949-206-0013
6
ASSEMBLY INSTRUCTIONS CONTINUED
It is highly recommended that two
persons assemble the product. Please do
not assemble it alone.
1.
Tighten the bottom control wire to the plastic
wire protection sleeve by pulling the guide
wire inside the right upright tube (C, D).
Position it to the side round hole in the right
upright tube, then insert the upright tubes (C,
D) into the two locations on the frame.
Secure them with bolts (a) and wrench
provided.
Please be aware that one person should hold
the upright tubes in place during the
assembly process.
2. Place the computer (A) on the left (C) and
right (D) upright, connect the cable from
the upright and the computer control
cable. After connecting the cables, place
the computer on the upright and fasten it
by bolt (b). Arrange the control cables and
fit them into the computer rack. Cover the
bolt with cover (E) as indicated in the
drawing.
