7
EN
Installing the Flight Battery
1. Lower the throttle.
2. Power on the transmitter.
3. Center the throttle trim.
4. Turn throttle hold on and move the fl ight mode switch to select Normal mode.
5. Install the fl ight battery on the battery tray, and secure it with the included hook and loop strap. Connect the battery
cable to the ESC.
CAUTION:
Always keep the power lead positioned AWAY from the elevator servo.
Failure to do so could cause the lead to get caught, resulting in a crash causing property damage and injury.
6. Do not move the helicopter until the fl ybarless control unit initializes.
7. The LED on the fl ybarless control unit turns solid blue and the ESC beeps when the helicopter is initialized.
8. Once initialized, ensure throttle is at low stick and the fl ight mode is set to normal, then turn off throttle hold and the
helicopter is ready for fl ight.
CAUTION:
Low voltage cutoff does not protect the Li-Po battery during storage. If you allow the Li-Po
battery voltage to fall below 3V per cell, you will damage the battery. The battery will no longer accept a
charge and you will need to replace the battery. The warranty does not apply to batteries damaged from over-
discharge.
Summary of Contents for BO-105 CB 130 X
