15
14
6.1 Getting Started
(When the DiSEqC Motor parameter is set as 1.2)
- Motor Step
: Select Motor Step
- Move
: Move the dish position to west/east by pressing
/
buttons.
- Go To
: Go to the position of the saved satellite.
- Motor Control
: Control motor by press
button ot the remote.
⍜
Recalculate
: Recalculate the position of all other saved satellites relative to the
known position.
⍜
Reset System
: Reset the position of all saved satellites.
⍜
Goto Reference
: Move the dish to the 0 position.
⍜
Set West Limit
: Edit & Save west limit by pressing
/
or
buttons.
⍜
Set East Limit
: Edit & Save east limit by pressing
/
or
buttons.
⍜
Enable Limit
: Enable the saved east and west limit.
⍜
Disable Limit
: Disable east and west limit.
⍜
Save
: Save the current setting of DISEqC 1.2 system.
<Figure 6-1-6>
6.1 Getting Started
4) Dish Setup
⊹
Press the MENU button to display the main menu.
⊺
Use
/
and
/
to move in the menu.
⊻
Press
on ‘Dish Setting’. The following window will appear. <Figure 6-1-4>
ҫ
Note : Enter a 4-Digit password if need arise. The default password is ‘0000’.
⊼
Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
- Satellite
: Select any satellite by pressing
/
buttons.
- Frequency
: If the default TP frequency is not appropriate, you can select another TP
frequency at which to check for signal
- LNB Power
: Select among ON/OFF/13V/18V.
- LNB Type
: Select among Universal/OCS/Single.
- LNB Freq
: Set the frequency of the LNB oscillator.
- 22KHz
: When not AUTO, set the signal path from LNB or switch by selecting a control
signal among 0/22KHz.
- DiSEqC 1.0 / 1.1
: Select DiSEqC protocol among OFF/1.0/1.1 as appropriate for your
configuration. <Figure 6-1-5>
- DiSEqC Motor
: Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your
Motor. <Figure 6-1-6>
⊽
Auto Scan
: Press Green button the remote to begin Auto Scan.
<Figure 6-1-4>
<Figure 6-1-5>
