7
EN
Installing the Mounting Plate
Installing the Gimbal
The CGO3 camera gimbal is compatible with 350 QX3
and Chroma
™
quadcopters. Install the appropriate
mounting plate using the 3 included M2.5 x 10 screws.
Do not overtighten.
IMPORTANT:
If you are mounting the CGO3 to the
350 QX3, you must fi rst install the 350 QX3 tall landing
gear (BLH8105).
Install the gimbal by lining up the mounting rails of the
gimbal and the mounting plate and pushing towards
the rear of the plate as shown at left until it locks into
place.
To remove the gimbal, push in the retaining clip at
the front of the mounting plate and pull the gimbal
forward.
Connect the harness from the gimbal power port to
either the exposed wire harness from the 350 QX3
or to the recessed plug in the bottom of the Chroma
quadcopter.
