13
EN
1. Lower the throttle stick to the lowest position
(A)
and center all trims.
2. Set the Flight Mode Switch to Stability Mode (FM0)
3. Power ON the transmitter
(B)
.
4. Slide the fl ight battery fully into the mount of the helicopter frame
(C)
.
5. Connect the power lead to the battery
(D)
, noting the correct polarity.
CAUTION:
Connecting the battery to the control board with reversed polarity
will cause damage to the control board, the battery or both. Damage caused
by incorrectly connecting the battery is not covered under warranty.
6. Place the helicopter on a fl at surface and leave it still until the red LED changes to
blue and glows solid, indicating initialization is complete.
If the LED on the control board fl ashes rapidly, proceed to the Transmitter and
Receiver Binding section to bind the helicopter and transmitter.
NOTICE:
Do not allow the helicopter to move until the LED on the control board is
solid blue.
If you experience issues during initialization, refer to the Troubleshooting Guide at the
back of the manual.
CAUTION:
Always disconnect the Li-Po battery from the aircraft when not
fl ying to avoid over-discharging the battery. Batteries discharged to a voltage
lower than the lowest approved voltage may become damaged, resulting in loss of
performance and potential fi re when batteries are charged.
Installing the Flight Battery
A
B
C
D
