English
19
4. Footswitch
Connect one of the following supported footswitches here.
1 button footswitch
Use any latching footswitch (e.g. a
)
lackstar F
:
-4
to switch between Channels 1
and 2 of the currently selected
)
ank.
Footswitch latched OFF (e.g.
3
ED extinguished on the F
:
-4
activates Channel 1
Footswitch latched ON (e.g.
3
ED illuminated on the F
:
-4
activates Channel 2
Blackstar FS-10 Footcontroller
This multi function footcontroller allows you to access all patches, toggle effects
and program patches.
MIDI footcontrollers
Functionality will depend on your footcontroller.
5. MP3/Line In
Connect the output of your mp3 or CD player here. Adjust the player’s volume to
match that of your guitar to enable you to play along.
NOTE:
The connection is mono.
6. Emulated Output
This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural tone for connection to a recording device or mixing desk
To make full use of the stereo effects, use a stereo jack to two mono jacks splitter
lead to feed two channels of the recording device or mixer. The output will also
function into a mono guitar type lead. Always use a good quality screened lead.
Turning the
=
olume knob (4
will control the Emulated Output level. The Master
=
olume only affects any connected speaker(s
/cabinet(s
.
NOTE:
To ‘silently’ record, set the Master
=
olume to zero. You may also record
from this output without a loudspeaker connected, but ensure that no loudspeaker
leads are connected to any of the loudspeaker output jack sockets of the amplifier,
as this will defeat the load protection circuit and will cause damage to the amplifier.
Rear Panel
1. Mains Input
The supplied detachable mains lead is connected here. The lead should only
be connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt get advice from a
qualified technician.
2. Speaker Outputs
ID:60TVP, ID:100TVP
There are two parallel speaker outputs for connecting external speaker cabinets.
The minimum load is 4 Ohms.
WARNING:
The combined impedance must never be less than 4 Ohms (e.g. 1 x 4
Ohm cabinet, or 2 x 8 Ohm cabinets
. Failure to correctly match the impedance of
the amplifier and speakers will damage the amplifier.
NOTE:
2 x ID
!
412 4 Ohm cabinets cannot be used together.
ID:260TVP
There are two speaker outputs (1x left channel, 1x right channel
for connecting the
internal speakers or external speaker cabinets.
The internal speakers are directly plugged into these outputs and must be unplugged
before external cabinets can be connected.
The minimum load is 4 Ohms.
WARNING:
The impedance of each output must never be less than 4 Ohms. Failure
to correctly match the impedance of the amplifier and speakers will damage the
amplifier.
ID:60TVP
The speaker output is for connecting the internal speaker or external speaker
cabinets.
The internal speaker is directly plugged into this output and must be unplugged
before an external cabinet can be connected.
The minimum load is 4 Ohms.
WARNING:
The impedance must never be less than 4 Ohms. Failure to correctly
match the impedance of the amplifier and speakers will damage the amplifier.
3. MIDI In
If using MIDI is required, connect the MIDI device here. Refer to the MIDI section for
more details. Always use a good quality MIDI lead.
English
18
