Version : 2020.1
32
Operating Instructions
N 500
1
Indicator light fence
2
Indicator light earth
3
Fastening holes
4
Earth connection
5
Fence connection
with reduced energy
6
Fence connection
with maximum energy
a.) Installation
Fastening holes (4) are provided for wall mounting. The unit must be mounted against a vertical, fireproof wall with the
connections at the bottom, see above picture, left part. For outside installation the device must also be protected against
exposure to rain and direct sunlight.
b.) Functional description of the appliance
Commission device
WITHOUT
fence and connection to earth. The control lights flash in time to the impulses (green or
red). The device is ready for operation. If control lights do not flash, the power supply or power supply line must be
checked first. If no fault can be detected, the device should be tested by a specialist.
c.) Functional description with CONNECTED fence system (ea fence)
1
Control light
fence
(1)
Flashing green:
State of fence ok = output voltage > 3500V = minimum requirement
Flashing red:
State of fence faulty = output voltage
≤
3500V, see operating instructions
enclosed, possible sources of error (fig. 2, pg.5)
2
Control light
earth (2)
Flashing green:
State of connection to earth ok; earth voltage < 1000 V
Flashing
red:
State of connection to earth faulty, earth voltage
≥
1000 V, see operating
instructions enclosed, possible sources of error (fig. 2, pg.5) and connection to
earth (pg.4)
Connection variants:
Erdung
Fence systems may be operated independent of each other at the fence connections (5 or 6).
The measured value indicated in the display (1) and the associated indicator light are nevertheless only capable of displaying
the exit exactly with maximum energy (6). If the indicator light flashes faster than once per second, the appliance must be
disconnected at once and checked by a technician before it can be used again.
New function in accordance with EN 60335-2-76
Following a delay time of 15 seconds this device delivers an output energy of no more than 5 joules.
With an increasing load the device increases its output energy after a delay time has lapsed and therefore automatically adjusts the
shock strength to the increased growth, weather conditions and fence status.
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system regularly, in accordance with
the conditions of use, at least once per day.
-
visual check of the appliance and the fence system
-
measurement of the minimum voltage of 2500V at each point of the fence
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, warranty terms and conditions and
potential sources of fault!
Mains plug is used as ON / OFF!
Connection to 230 V ~!
Fence system closed:
Fence system open:
earth
earth
1
2
4
3
5
6
3
This
energizer
shall
not
be
used
as
an
animal
trainer
(inside
a
barn).
