Version : 2020.1
26
Fence connection
Earth connection
3 m 3 m
Earthing
The correct earthing is extremely important, as the complete function of the appliance depends on it.
After the complete installation, knock a rust-protected grounding rod into the ground up to the limit stop at a
place with preferably high, continuous moisture.
If necessary in dry areas or. grounds with low conductivity, one or more additional earth rods have to be used (length at
about 1 m). These earth rods have to be knocked into the ground at a distance of approximately 3 m from each other.
Put to service
The enclosed specific instruction manual for the appliance has to be read before being put to service.
Always make sure that the appliance is switched off as well as disconnected from the network before being
connected to the energizer unit.
Connection plan of the electric fence appliance:
• With battery-fencers, pay attention on the right polarity at connection with the battery.
black = negative; red = positive.
230V~:
Operation only at 230V mains v10/-15%, frequency 50 or 60 Hz, pure sine form. Operation on inverters (solar
power systems, etc.) will result in device failure. Damage which occurs from operation on inverters is excluded from the
guarantee.
Maintainence of battery and accumulator
The voltage of the batteries and accumulators have to be checked regularly with an as exact as possible measuring
instrument.
9 volt dry-battery ( 9V appliances ):
Before using the battery, the sticker which closes the air- openings, has to be removed.
Only now, the battery is ready for use.
Attention: even a discharged alkaline 9V–battery can reach, some time after the switch off of the appliance, an
almost normal voltage of 7.5 – 8.5 volts. Nevertheless the battery is spent and should be detoxified, as with normal
drive the voltage will again fall under 4,5V (ideal value: 7.8 - 9V, during the current operation!).
Various 9 V appliances can also be driven with 12 volt. Important: In this case a corresponding
adapter-cable from the manufacturer has to be used and the 12V hints have to be heeded.
12 volt accumulator ( 12V appliances ):
A 12V lead accumulator is already deeply discharged with the low burden which is typical for electric fencers, at a
voltage of 11.9V and should be reloaded without any delay. In order to guarantee an optimum lifetime we advise a
recharge of the accumulator already at a voltage of 12.1 volt.
Also with an only short-term discharge under 11V a normal lead-accumulator will be durably damaged.
Through overload, what means further charging of the accumulator after attainment of a maximum voltage of 13,8V,
not only the accumulator will be damaged, but also acid of the accumulator may tread out which can destroy the
electric fencer (ideal value: 12,6 – 13,8V).
By no means, an accumulator may be connected to the appliance for a longer time without any control!
12V accumulators may only be reloaded in aired rooms with a suitable charger.
In case of longer intermissions (eg.: winter-intermission) the accumulators have to be connected to a charger which
is equipped with a maintenance-grade. Otherwise the accumulators could be durably damaged because of their self-
discharge.
Appliances which run with a solar-module > 25 W require an additional solar-regulator.
Appliances which run with a solar-module / mains-adapter in combination with a 12V gel-accumulator require an
additional solar-regulator.
If the batteries as well as accumulators are discharged, they have to be properly detoxified!
Warranty
Beside the statutory guarantees we give a warranty according to the following conditions:
•
Warranty starts with date of purchase. Warranty claims will only be acknowledged together with the invoice or
the payment voucher. Costs for shipping and return are for account of the buyer.
Warranty repairs will be free of charge. We reserve the right to supply an other equivalent appliance .
•
Warranty is only valid with appropriate use and according to the instruction manual and is deemed invalid with
unauthorized repairs and use as well as with use of non-genuine spare parts.
We shall rectify any faults caused by material defects or manufacturing faults, by repairing or replacing the
device at no charge and at our discrepancy.
•
Any repairs or spare part deliveries will not extend the original warranty durage.
•
Duration of warranty as well as the address of the warrantors please find on the enclosed specific instruction
manual.
