5
High Performance IR CCTV Bullet Camera User Manual
SECTION 2: INSTALLATION
5.
Route the drop cable through the hole through the base plate, or through the cable guide in the mounting bracket, then
attach the camera to the base plate using the four (4) machine screws provided.
6.
Connect the camera drop cable to video and power cables as required.
NOTE
Drop cable connectors are not waterproof.
2.3 Camera adjustments
In this procedure, set the camera to point at your surveillance target. Rotate the far - near and tele - wide rings to frame the video
image.
8.
Apply power to the camera.
9.
If using a hand-held CCTV video setup monitor with your camera:
a.
Remove the cover to the OSD control panel by unscrewing it counter clockwise.
BLK-CPT235VH OSD Control Panel
BLK-CPT237VH, BLK-CZT242VH,
BLK-CZT243VH OSD Control Panel
b.
Connect the BNC adapter cable to the VIDEO TEST port on the OSD control panel.
c.
Connect a CCTV setup monitor to the BNC adapter cable.
10. If using a CCTV video system monitor to setup your camera, connect the video output of the camera to your CCTV monitor.
11. Verify that video from the camera can be seen on the monitor.
12. While observing video from the camera, loosen the bracket adjustment ring and the hex screws.
