6
www.digiop.com
SECTION 2: INSTALLATION
13. Point the camera at your surveillance target, then tighten the bracket ring and hex screws to lock the bracket in place.
Bracket Adjustment
Ring
Far - Near
Adjustment
Bracket Adjustment
Hex Screws
Tele - Wide
Adjustment
OSD Control
14. Rotate the
Far - Near
adjustment ring and the
Tele - Wide
adjustment ring to improve the image of the your
surveillance target.
15. Configure your camera using the software menus in the OSD. See
Software Setup
in the following section of this
manual.
2.3.1 LED LEVEL adjustment
The LED LEVEL for these cameras is preset at the factory. However, an adjustment screw is provided on the OSD panel of the BLK-
CPT237VH, BLK-CZT242VH and BLK-CZT243VH cameras for installations where the image brightness in dark conditions is still not
satisfactory after performing a Software Setup of the camera. The LED LEVEL for the BLK-CPT235VH camera is not adjustable.
To adjust the LED LEVEL (BLK-CPT237VH, BLK-CZT242VH and BLK-CZT243VH cameras only):
1.
Operate the camera in a dark environment.
2.
Unscrew the OSD panel access cover.
3.
While observing the video image from the camera, use a screwdriver to turn the LED LEVEL screw to counter-clockwise to
brighten the image, and/or clockwise to darken the image until the image brightness is acceptable.
4.
Reinstall the OSD panel access cover.
