5
To activate anti-carjack protection:
1. Make sure the ignition is on and all doors
are closed.
2. Press the valet switch once.
If the carjack feature is triggered:
• The LED will flash rapidly.
• Warn Trigger will activate after 30
seconds. The parking lights will begin
flashing and the siren will begin chirping.
• Full Trigger will activate after 60 seconds.
The siren will sound continuously and the
starter defeat will turn on and remain on
until the carjack feature is deactivated .
To deactivate anti-carjack if not triggered:
Press the valet switch for 3 seconds.
• The siren will chirp 3 times.
- or -
Turn off the ignition with all doors closed.
To deactivate anti-carjack after Warn Trigger:
Press the valet switch for 3 seconds.
• The siren will chirp 3 times.
- or -
Press transmitter button 2.
To deactivate anti-carjack after Full Trigger:
Press the valet switch for 5 seconds.
- or -
Enter PIN if programmed for PIN mode.
SECURE PIN CODE
The system may be programmed to override
only when a 2-digit personal identification
number is entered using the valet switch. PIN
code override mode must be selected during
installation or PIN code mode will not operate.
To disarm the system with a PIN code:
1. Open door, alarm system will trigger
2. Turn ignition on
3. Press the override switch the number of
times equal to the first digit of the PIN.
4. Turn ignition off, then back on.
5. Press the override switch the number of
times equal to the second digit of the PIN.
6. Turn ignition off.
• The system will disarm.
Example: PIN=2,3 Press valet switch two
times, turn ignition off then back on, and
press valet switch 3 more times.
CREATING A SECURE PIN CODE
When first programmed for PIN code override
mode, the default code is set to 1,1. To change
the PIN code first program the system for PIN
code operation, then follow the steps below:
To change the PIN code:
1. Be sure the ignition is off and the system
is disarmed.
2. Press the valet switch 4 times.
3. Turn ignition on.
• The siren will chirp 4 times.
4. Press the valet switch once.
• The siren will chirp once and enter 1st
digit PIN programming.
5. Pick a 1st digit number from 1 to 4, and
press the transmitter button equal to that
number (example: number 2=button 2).
• The siren will chirp a number of times
equal to the button pressed.
6. Press the valet switch again.
• The siren will chirp twice and enter 2nd
digit PIN programming.
7. Pick a 2nd digit number from 1 to 4, and
press the transmitter button equal to that
number (example: number 3=button 3).
• The siren will chirp a number of times
equal to the button pressed.
8. Turn ignition off.
NOTE: Record the new PIN. Once the PIN
code mode is entered the standard Emergency
Override will not disarm the system.
7250 rev 2 9-23.qxd 9/24/2004 12:54 PM Page 5
