9
tach setting has been learned, or four
times to confirm the Smart Start mode
has been learned. If the parking lights do
not flash to confirm tach learning, choose
a different tach source.
4. Turn ignition off.
NOTE: If the tach setting is not properly
learned, the system will not be able to remote
start and the parking lights will flash 7 times
when button 3 is pressed. Also note that
anytime a Default Reset is performed, or the
tach wire is changed or disconnected, the tach
signal must be relearned. If the system seems
to be over or under cranking the starter, please
see
Cranking Adjustments.
Manual Learn Mode
The manual learn mode aids in setting the tach
signal for vehicles which may not remote start
properly after auto learning. The Manual Learn
mode allows a simple way to learn the proper
idle speed for vehicles which may
1. Start the vehicle using the key.
2. Let the vehicle run until the engine idle
speed drops. If the idle speed does not
drop, skip to
Forced Low Idle Learn Mode.
3. Press and hold the brake pedal.
4. Press the valet switch.
5. Press the valet switch again and hold until
the parking lights flash to confirm manual
learning is complete.
Forced Low Idle Learn Mode
To manually force the idle speed down for
proper learning on some vehicles:
3. Set the parking brake.
4. Press and hold the break pedal while
putting the vehicle into reverse gear.
• The idle speed should drop.
5. Press the valet switch.
6. Press the valet switch again and hold until
the parking lights flash to confirm manual
learning is complete.
Cranking Adjustments
There may by instances where even with
proper tach learning, the vehicle may slightly
over or under crank the starter. To fine-tune
the starter crank time, follow the steps below.
Over-Cranking Adjustment:
1. Within 3 seconds, turn the ignition on, off,
on, off and leave on.
2. Press the valet switch.
• The parking lights will flash.
• The horn will honk once (optional).
3. Press and release transmitter button 4.
4. Press the valet switch twice.
• The LED will flash twice and repeat.
5. Press and hold the valet switch again.
• The parking lights will flash and the horn
will honk (optional) to indicate that the
crank time setting has been decreased by
one step.
6. Release the valet switch to exit.
7. Test remote starter and if necessary
repeat steps 1-6.
Under-Cranking Adjustment:
1. Within 3 seconds, turn the ignition on, off,
on, off and leave on.
2. Press the valet switch.
• The parking lights will flash.
• The horn will honk once (optional).
3. Press and release transmitter button 4.
4. Press the valet switch three times.
• The LED will flash three times and
repeat.
5. Press and hold the valet switch again.
• The parking lights will flash and the horn
will honk (optional) to indicate that the
BW651 final.qxd 10/18/2005 10:58 AM Page 9
